Instant feedback with problems.

It’s always possible that you have a problem with your laminator. However, many times it’s very minor and often a small mistake of the operator because of lack of knowledge. Wouldn’t it be nice that the laminator will give you the solution?

Yes. Already integrated in Shield.

The easy to use control panel gives you error codes corresponding with LED lights. Small user problems usually are:

  • Safety sensor blocked by material or fingers.
  • Table sensor not completely closed.

However, also in the very small case of serious defects, the control panel can already give the correct codes for the distributor/service company often eliminating a on-site visit or making sure they already have the correct parts. This saving lots of time, money and valuable production time of the signmaker.

Available on: E-lam, Shield, Shield+

display